Mine was A wire - I was lucky (so far). One electrical whiz on the AVA site just repoved, repaired and/or replaced 4 wires in the ignition harness. Good luck Clyde.

The one I repaired was also only a single wire. I think it's unusual for more than one wire to go at once.

You are right, I don't want to replace it. I opened up the little round white module that all the wires are soldered to and found some of the copper contacts coroded. After a thorough cleaning I don't have the cutting out like I did before, but the starter circuit is still not engaging. In the morning I will try to trace back the wires from the ignition switch starter circuit and see if I can find a relay or fuse blown. It's possible I may have fixed the switch and blown a fuse at the same time. Thanks for the info.

Maybe it's a fuse but I think ot's a broken wire.