Actually, I don't need the key assembly. What I need is the wire harness that attaches to the bottom of the key assembly.
I am tracing wires, but no visible breaks. Now I am looking for internal break in wire (all wires ohm out perfectly)but I am afraid it is at the end of the harness where the wires are soldered to the little round plastic covered module that attaches to the bottom of the key module. The key module is easily disconnected from the wire harness so you don't have to replace that portion. (Key assembly)I am just trying to replace the bottom portion of the key assembly so I won't have to worry about replacing or re-cutting keys.
Thanks for looking into this.